Pengaruh Penambahan Karet Alam Cair (Lateks) terhadap Kuat Tekan Marshall pada Campuran Aspal AC-WC
Abstract
To improve each quality of 60/70 penetration oil asphalt so that it becomes harder, has a high softening point, is more elastic, has good adhesion and is more durable, it is necessary to add other materials and in this research it was tried with Laston AC-WC using additional materials. liquid natural rubber (latex) This research is expected to determine the characteristics of adding liquid natural rubber to the Optimum Asphalt Content (KAO) based on Marshall parameters, so that it can provide good results for flexible pavements in the future. The aim of this research is to obtain optimum asphalt content values with asphalt percentage variations of 4.5%, 5%, 5.5%, 6%, 6.5%, and 7% from the Marshall Compressive Strength Test results and to obtain content values optimum asphalt with variations in the percentage of liquid natural rubber of 3%, 5%, 7% and 9% from the Marshall Compressive Strength Test results. The research method used was an experiment in the laboratory based on the 2018 Revision 2 Technical Specifications. From this research, the results were that KAO from test results with variations in standard asphalt was 5.9% and KAO from marshall test results with variations in liquid natural rubber content was 4.5%.
Keywords
Full Text:
PDFReferences
Afriaziz, Andi. Sebayang, Nusa dan Priskasari, Ester. 2021. Pengaruh Penambahan Karet Alam Pada Campuran Aspal Beton Lapis Aus Dengan Filler Fly Ash. Malang : Institut Teknologi Nasional Malang.
Amal, Andi Syaiful. 2012. “Pemanfaatan Getah Karet Pada Aspal Ac 60/70 Terhadap Stabilitas Marshall Pada Asphalt Treated Base (ATB).” Media Teknik Sipil 9 (1).
Bina Marga, 1999. Pedoman Perencanaan Campuran Beraspal Dengan Pendekatan Kepadatan Mutlak. Jakarta Selatan : PT. Mediatama Saptakarya.
Bina Marga, 2017. Manual Desain Perkerasan Jalan. Kementerian Pekerjaan Umum dan Perumahan Rakyat, Indonesia.
Bina Marga, 2018. Spesifikasi Umum Pekerjaan Konstruksi Jalan Dan Jembatan Revisi 2. Kementerian Pekerjaan Umum, Indonesia.
Evrilyana, Cici Sri Isma, Ahmad Ridwan, And Yosef Cahyo. 2018. “Penelitian Campuran Aspal Beton Menggunakan Pasir Vulkanik Botol Plastik.” Jurnal Manajemen Teknologi & Teknik Sipil 1 (2).
Faizal & Putri, Listya. 2018. “Perkerasan Lentur Asphalt Beton.” Journal of Chemical Information and Modeling 53(9): 8–24.
Fitri, Suraya, Sofyan M Saleh, and Muhammad Isya. 2018. “Pengaruh Penambahan Limbah Plastik Kresek Sebagai Subsitusi Aspal Pen 60/70 Terhadap Karakteristik Campuran Laston AC–BC.” Jurnal Teknik Sipil 1 (3): 737–48.
Hermadi, Madi, and Yohanes Ronny. 2015. “Pengaruh Penambahan Lateks Alam Terhadap Sifat Reologi Aspal” 1 (2): 105–14.
Kafabihi, A., Wedyantadji, B., & Imananto, E. I. (2020). Penggunaan Aspal Buton Pada Campuran AC-WC (Asphalt Concrete - Wearing Course). Gelagar, 2(2), 36–44.
Lagaligo, Dandy, Lambang Basri Said, and Andi Alifuddin. 2022. “Pengaruh Temperatur Pemadatan Pada Campuran Beton Aspal (AC-WC) dengan Bahan Tambah Karet Alam terhadap Ketahanan Deformasi dan Kuat Tarik Tidak Langsung.” Jurnal Konstruksi (JK-TIS) Vol. 01, No. 11.
Mashuri. 2010. Karakteristik Aspal Sebagai Bahan Pengikat Yang Ditambahkan Styrofoam. SMARTek, 8(1), 1-12.
Sukirman, Silvia. 1992. Perkerasan Lentur Jalan Raya. Bandung : Nova.
Sukirman, Silvia. 1999. Perencanaan Tebal Struktur Perkerasan Lentur. Bandung : Nova.
Sukirman, Silvia. 2003. Beton Aspal Campuran Panas. Bandung : Grafika Yuana Marga.
Tanjung, Rifin. 2020. Pengaruh Pemanfaatan Karet (LATEKS) Alam Sebagai Bahan Tambah Aspal Terhadap Stabilitas Marshall. Medan : Universitas Medan Area.
DOI: http://dx.doi.org/10.33087/talentasipil.v8i2.828
Refbacks
- There are currently no refbacks.
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
Jurnal Talenta Sipil, Faculty of Engineering, Batanghari University |
