Perencanaan dan Analisis Keefektifan Penempatan Dinding Geser terhadap Perilaku Struktur dengan Software ETABS

Serina Anggraini, Erna Septiandini, Intan Puspa Wangi

Abstract


The rise of high-rise building development is due to land limitations and also the soaring population. The vulnerability of high-level building structures to lateral forces, one of which is the earthquake force, requires that high-level building structures be able to withstand the lateral forces that occur. There are several structural systems in resisting lateral forces, including moment-bearing frame systems and shear wall systems. The purpose of this research is to compare the structural analysis of three alternative plans with different shear wall placements. The structural analysis uses ETABS software that refers to SNI 1726: 2019. The results of the research from three alternative models, show that the smallest deviation value towards the X-axis and Y-axis, and the average deviation value is 19.787 mm in the X-direction and 17.220 mm in the Y-direction. The requirements for a dual system with a special moment-bearing frame are also met in alternative planning 2 with a contribution of forces acting on the portal of 36.7340% in the X-direction and 31.1996% in the Y-direction. The amount of mass participation that occurs is above 90% and in accordance with the requirements specified by SNI.


Keywords


Shear Wall; ETABS; Tall Building; Shear wall.

Full Text:

PDF

References


Andalas, G., 2016. Analisis Layout Shearwall Terhadap Perilaku Struktur Gedung.

Imran, I., 2010. Perencanaan Struktur Gedung Beton Bertulang Tahan Gempa. In: s.l.:ITB, p. 195.

Karna, I. and Brahmantya, P.B., 2015. Perbandingan Perilaku Struktur Bangunan Tanpa Dan Dengan Dinding Geser Beton Bertulang. Bali: Fakultas Teknik Universitas Udayana.

Kurnia, A., Dewi, S.H. and Kurniawan, M., 2018. Pengaruh Posisi Dinding Geser Terhadap Kinerja Struktur Pada Gedung Tidak Beraturan Dengan Menggunakan Metode Response Spectrum. JURNAL SAINTIS, 18(1), pp.15-24

Kusuma, Y.N., 2020. Studi bentuk dan layout dinding geser (shear wall) terhadap perilaku struktur gedung bertingkat. KURVA MAHASISWA, 1(1), pp.1828-1844.

Maimunnah, S., 2021. Respon Gempa Gedung Beton Bertulang 20 Tingkat dengan Variasi Tata Letak Dinding Geser. Jurnal Teknik Sipil Institut Teknologi Padang, 8(2), pp.59-65

McCormac, J.K., 2003. Desain Beton Bertulang Edisi Kelima (Design of Reinforced Concrete Fifth Edition). Erlangga: Bandung

Nasional, B. S., n.d. In: SNI 1726:2019 Tata Cara Perencanaan Ketahanan Gempa untuk Struktur Bangunan Gedung dan Nongedung. s.l.:Pekerjaan Umum, p. 254.

Nasional, B. S., n.d. SNI 1726:2019 Tata Cara Perencanaan Ketahanan Gempa untuk Struktur Bangunan Gedung dan Nongedung. In: s.l.:s.n., p. 248.

Nasution, A., 2009. Analisis dan Desain Struktur Beton Bertulang. In: s.l.:s.n., p. 667.

Ruslim, A., Kuddu, D. and Mushar, P., 2020. Peranan Aplikasi ETABS Dalam Menentukan Besaran Optimum Struktur Shear Wall Terhadap Bangunan Kondominium 30 Lantai. Jurnal Lingkungan Binaan Indonesia, 9(1).

Sansujaya, E., Pah, J.J. and Udiana, I.M., 2021, April. Studi Kefektifan Dinding Geser pada Bangunan Tingkat Tinggi Dalam Mengurangi Simpangan Struktur. In Jurnal Forum Teknik Sipil (J-ForTekS) (Vol. 1, No. 1, pp. 24-34)

Usmat, N.A., Imran, I. and Sultan, M.A., 2019. Analisa Letak Dinding Geser (Shear Wall) Terhadap Perilaku Struktur Gedung Akibat Beban Gempa. Techno: Jurnal Penelitian, 8(2), pp.297-307.




DOI: http://dx.doi.org/10.33087/talentasipil.v7i1.437

Refbacks

  • There are currently no refbacks.


Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.

Jurnal Talenta Sipil, Faculty of Engineering, Batanghari University
Adress: Fakultas Teknik, Jl.Slamet Ryadi, Broni-Jambi, Kec.Telanaipura, Kodepos: 36122, email: talentasipil.unbari@gmail.com


Creative Commons License This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.