Pengaruh Metode Analisis Stabilitas Lereng 3D terhadap Faktor Keamanan dan Kebutuhan Perkuatan pada Timbunan di Atas Tanah Lunak

Aisiyah Pramaisela Hapsari, Queen Arista Rosmania Putri Sumarsono

Abstract


Three-dimensional (3D) slope stability analysis is increasingly used in geotechnical planning because it is able to represent landslide conditions more closely than two-dimensional (2D) analysis. Differences in results between analytical methods and software have the potential to result in different reinforcement requirements. This study aims to compare the three-dimensional slope safety factor values obtained using the analytical method with the Hovland formula and Plaxis LE software and evaluate their influence on the need for geotextile reinforcement. The analysis was conducted using the three-dimensional Limit Equilibrium Method (LEM) on several variations in width, height, slope, and the ratio of the length of the landslide plane to the height of the embankment. The results showed that the 3D safety factor values ranged from 0.461 to 1.512. A comparison between the safety factors obtained from the analysis and the Hovland method showed that the ratio varied between 0.256 and 1.618, indicating a considerable difference in safety factor values between the PLAXIS LE 3D results and the Hovland method. The required geotextile reinforcement ranged from 0 to 37 layers and increased with increasing ls/H values, embankment width, and embankment height. The results of the study show that the selection of the three-dimensional slope stability analysis method influences the safety factor and the need for geotextile reinforcement, so it needs to be considered in the geotechnical planning process.

Keywords


Slope Stability; 3D analysis; Safety Factor; Limit Equilibrium Method; Geotextile.

Full Text:

PDF

References


Badan Standardisasi Nasional. (2017). SNI 8460:2017 Persyaratan perancangan geoteknik. Badan Standardisasi Nasional.

Afriade Siregar, C., Ali Syakir Ashidik, F., & Garnida, H. (2021). Perbandingan Stabilitas Lereng Antara Metode Keseimbangan Batas (Lem) Dan Metode Elemen Hingga (FEM) Studi Kasus: Kereta Api Cepat Indonesia Cina (KCIC) Walini, Kabupaten Bandung Barat. In Seminar Nasional Ketekniksipilan, Infrastruktur dan Industri Jasa Konstruksi (KIIJK) (Vol. 1, Number 1).

Azanna, D. O. (2021). Analisis stabilitas lereng tiga dimensi. Jurnal Talenta Sipil, 4(2), 210–213. https://doi.org/10.33087/talentasipil.v4i2.76

Banne, S. P., Dhawale, A. W., Patil, R. B., Girase, M., Kulkarni, C., Dake, M., & Khan, S. (2024). Slope Stability Analysis of Xanthan Gum Biopolymer Treated Laterite Soil Using Plaxis Limit Equilibrium Method (PLAXIS LE). KSCE Journal of Civil Engineering, 28(4), 1205–1216. https://doi.org/10.1007/s12205-024-0553-2

Dai, Z., Yang, J., Dai, R., & Zhu, Q. (2022). Three-Dimensional and Threefold Nonlinear Numerical Modeling for Slope-Stabilizing Pile. KSCE Journal of Civil Engineering, 26(11), 4390–4406. https://doi.org/10.1007/s12205-022-1474-6

Fellenius, W. (1936). Calculation of the stability of earth dams. Proceedings of the Second Congress on Large Dams, 4, 445–462.

Firincioglu, B. S., & Ercanoglu, M. (2021). Insights and perspectives into the limit equilibrium method from 2D and 3D analyses. Engineering Geology, 281, 105968. https://doi.org/10.1016/j.enggeo.2020.105968

Fredlund, M. D., Lu, H., & Fredlund, D. G. (2011). Three-dimensional limit equilibrium slope stability benchmarking. In Slope Stability 2011 Conference.

Hovland, H. J. (1977). Three-dimensional slope stability analysis method. Journal of the Geotechnical Engineering Division, ASCE, 103(9), 971–986.

Luo, F., Zhang, G., Liu, Y., & Ma, C. (2018). Centrifuge modeling of the geotextile reinforced slope subject to drawdown. Geotextiles and Geomembranes, 46(1), 11–21. https://doi.org/10.1016/j.geotexmem.2017.09.001

Pratiwi, D. S., Lesmana, N., & Hamdhan, I. N. (2020). Analisis Stabilitas Lereng Menggunakan Model Numerik 3 Dimensi Studi Kasus Lereng Sekolah Terpadu di Kecamatan Jonggol Bogor. Indonesian Journal of Construction Engineering and Sustainable Development (CESD), 3(2), 54–63. https://doi.org/10.25105/cesd.v3i2.8323

Qin, Y., Chen, Y., Lai, J., Qiu, J., Wang, Z., Liu, T., & Zan, W. (2024). Failures in loess slope-tunnel system: An overview of trigging sources, acting mechanism and mitigation strategies. Engineering Failure Analysis, 158, 107996. https://doi.org/10.1016/j.engfailanal.2024.107996

Shoffiana, A., Lastiasih, Y., & Rendy Satrya, T. (2022). Comparison of Embankment Reinforcement Requirements with Geotextile on Soft Soil with 2D and 3D Slope Stability Analysis Methods. Journal of Infrastructure and Facility Asset Management, 4(2).

Sun, Z., Wang, B., Li, Y., Xu, J., & Ji, J. (2023). 3D limit analysis of rock slopes based on equivalent linear failure criterion with tension cut-off. Journal of Rock Mechanics and Geotechnical Engineering, 15(12), 3118–3130. https://doi.org/10.1016/j.jrmge.2023.02.009

Zhang, F., Jia, S., & Gao, Y. (2024). Recent advances in stability analysis and design of 3D slopes. Frontiers in Built Environment, 10. https://doi.org/10.3389/fbuil.2024.1410474

Zhang, L. L., Fredlund, M. D., Fredlund, D. G., Lu, H., & Wilson, G. W. (2015). The influence of the unsaturated soil zone on 2-D and 3-D slope stability analyses. Engineering Geology, 193, 374–383. https://doi.org/10.1016/j.enggeo.2015.05.011




DOI: http://dx.doi.org/10.33087/talentasipil.v9i2.1432

Refbacks

  • There are currently no refbacks.


Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.

Jurnal Talenta Sipil, Faculty of Engineering, Batanghari University
Adress: Fakultas Teknik, Jl.Slamet Ryadi, Broni-Jambi, Kec.Telanaipura, Kodepos: 36122, email: talentasipil.unbari@gmail.com

Creative Commons License This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.